Steam-A-Seam Directions

"Steam-A-Seam is the most innovative fusible web. It is so much easier to use and cuts loose your creativity."

Jane Krause
Plain Jane Creations

Pre-wash fabric to remove sizing and other chemicals which may prevent the fabric from sticking to the web. These instructions explain how to use Steam-A-Seam 2.

If you are using Steam-A-Seam sticky back, trace directly on the web and remove paper liner. Follow steps 2 and 3. After cutting the appliqué pieces, simply position on the background and press.

Get more information about Steam-A-Seam!
Steam-A-Seam directions
Steam-A-Seam guide
Steam-A-Seam projects

Trace appliqué design in reverse on paper liner and remove the second liner. (Check to see which liner removes first by peeling apart at the corner. Trace on the liner still attached to the web.) Skip tracing if you are not using a pattern.

Stick Steam-A-Seam 2 to the wrong side of the appliqué material.

Cut Steam-A-Seam 2 and material together along traced lines.

Peel off remaining paper liner (leaving the web on the fabric) and stick appliqué to second material. Reposition as desired.

Press for 10-15 seconds for cotton fabric (longer with a press cloth). Adjust temperature and pressing time to suit your fabric. Repeat, slightly overlapping pressed areas until complete.

Machine wash and dry at low heat or dry-clean. Not recommended for use with dryer sheets.

Frequently Asked Questions · Where To Buy · Wholesale Information · Contact Us